BridgeWave AR80 - Manual (Page 28)

AR/GE/FE/U 80/80X Installation Manual
23 580­00519 rev. D
13. Repeat these steps on far end radio.
3.9.5 Fine Adjustment
14. Ensure to loosen the “fine adjustment” bolt (the small eye bolt).
15. Pan antenna slowly from left to right and capture the highest RSL voltage peak.
16. See Figure 3.9.5­1 below to help guide you in obtaining the highest RSL voltage reading.
17. Tighten down the azimuth adjustment bolts.
18. Loosen the two bolts holding the antenna to the antenna mount.
19. The vertical fine adjustment bolt is not designed to be tightened; use the “hex nut” to fine
(and course) adjust the elevation (vertical position) to highest RSL value.
20. While monitoring the voltmeter, begin to align the vertical position of the antenna to obtain
the highest RSL voltage level.
21. Once completed, this fine adjustment must be repeated at the remote end of the system, if
you have not obtained the “target” RSL voltage for the given path distance (see RSL Vs.
distance chart in Appendix B).
22. If you have not obtained the “target” RSL voltage for the given path distance (or you want to
further improve it), you will need to re­align the antenna, go back to the original site you
started with and restart steps 14­21 and re­align again. See Figure 3.9.5­1 below of a
conceptual illustration of the antenna beam to keep in mind while you perform a re­
alignment.
23. Once again, the very narrow beam width of these antennas (0.4º and 0.9º) makes it necessary
to completely tighten the bolts of the azimuth adjustment while adjusting the elevation and
vice versa.
Verify that the RSL voltage falls within the expected range based
on the graph in Appendix B.