HCO VH400HD - Manual (Page 14)

Page | 13
2. Select YES to update and push OK
ADDITIONAL INFORMATION
TRANSFERRING PICTURES AND VIDEO TO A COMPUTER:
Pictures and video can be removed in one of two ways:
1. SD memory card can be removed (ALWAYS ensure
camera is OFF before removing) and transferred to
computer or SD card reader.
2. Connect camera to computer using USB cable.
i. Turn camera ON (may not be required)
ii. Computer will recognize camera and prompt you to
open file or save pictures
FIRMWARE UPDATES
This camera is designed to accommodate future firmware
updates if required.
1. Copy the firmware update files onto the SD card root
directory (do not place in any file)
2. Insert SD card into the camera
3. Push and hold UP arrow while turning camera to
SETUP mode
4.
ISP… will come across screen until update is complete
5. Turn OFF when screen goes blank and remove
batteries.
6. Replace batteries and turn camera to SETUP mode
7.
Confirm new firmware version by checking ‘Camera
Information” (see instructions)
TROUBLESHOOTING
1. The camera does not turn ON
i. Ensure batteries are inserted properly with correct
polarity and fully charged. If possible test each battery