IDX VW-5 - Manual (Page 11)

Chapter 3 Setup Menus
The following lists a step by step set-up procedure.
Step 1~4 VW-5TX Transmit Unit
Step 1 Connect power cord
Connect power cord to AC adaptor.
Attach AC adaptor to DC IN jack on VW-5TX unit.
Step2 Power On
Press the power button on the rear to turn the power ON.
Step 3 Connect video source
Connect your Video device (DVD, VAR, PVR, STB or BS) using the
supplied S-Video or AV video cable
Step4 Video Input
Connect AV cable to video input jack and/or connect S-Video cable
to S-Video IN jack on the VW-5TX unit. If both signals are available
the S-Video will be the priority and used due to its higher quality.
IR Function
If you require use of a remote control connect the included IR cable
at the back of the VW-5TX unit. Then locate the LED head module of
the cable in front of the usual IR receive point of the input source
(e.g. DVD player, cable box)
Step 5~8 VW-5RX Receive Unit
Step5
Connect power cord
Connect power cord to AC adaptor.
Attach AC adaptor to DC IN jack on VW-5RX unit.
Step6 Power On
Press the power button on the rear to turn the power ON.
Step7 Video Output
Connect AV cable to video output jack and /or connect S-Video
cable to S-Video OUT jack, as required by the display unit used.
23