Kino Flo Wall-O-Lite User Manual
Page 6
6
A
D
E
C
B
A) Manual Selector Dial: Turns lamps on and off manually without connecting DMX
Cable to Fixture.
B) Individual Lamp / Fixture Switch: Converts between INDIVIDUAL LAMP and
FIXTURE methods of DMX control.
C) DMX Address: Sets DMX Address of Fixture.
D) DMX TERMINATE Switch: Terminates DMX signal at the end of Fixture series.
E) DMX-In & DMX-Out: DMX-IN receives DMX signals from Dimmer Board, DMX-
OUT relays DMX signal through to other Fixtures or Instruments.
Power Panel
G
F
F) Power Switch: Has a built-in indicator light, which can detect if AC power is
present in power cord. "O" = OFF position
G) Fuse: Provides circuit protection. Note: If Fuse is "blown" or "open" replace with
same type of fuse rating as marked.
IMPORTANT!
The dimmer board/light console should have its channel set to LINEAR light output
response. (LINEAR response is the default setting on most dimmer boards.)