Kino Flo Wall-O-Lite - Manual (Page 7)

Provide 120 Volt AC primary power.
Do not dim the fixture through a dimming circuit.
If powering the fixtures through a dimmer board, set the dimmer profile to
non-dim.
Load Considerations:
Kino Flo ballasts are not power factor corrected. They will draw double the
current on the neutral from what is being drawn on the two hot legs. On large
installations it may be necessary to double your neutral run so as not to
exceed your cable capacity.
The DMX Wall-O-Lite Fixture may be operated manually with the Manual
Lamp Selector Dial. The Dial enables you to turn lamps on and off with an
“inside-out” pattern (i.e., if all lamps are on, the outside tubes will turn off
first).
Note: In lamp position 2 and 4, two lamps light simultaneously. In positions
5-10 individual lamps light.
DMX Wall-O-Lite Switching
Note: Manual lamp switching is disabled as soon as DMX cables are applied.
7