Klimaire GM80S Series - Manual (Page 5)

í
I&O manual
í
I&O manual
FOR YOUR SAFETY
“WHAT TO DO IF YOU SMELL GAS”
Cover old lighting instructions with this label. Note: Rating plate must be left visible for future reference.
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
Use only your hand to turn the gas control switch. Never use
call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
any phone in your building.
neighbors phone. Follow the gas suppliers
Instructions.
fire department.
This appliance does not have a pilot. it is equipped with an
ignition device which automatically lights the burner.
Do not try to light the burner by hand.
BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas ls heavier than air and will settle on the floor.
WARNING
A.
C.
D.
B.
1. STOP! Read the safety information above on this
label.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the burner. Do not try to
light the burner by hand.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed. 3. Remove control access panel.
4. Push gas control to “OFF”. Do not force.
5. Replace control access panel.
5. Remove control access panel.
6. Wait five (5) minutes to clear out any gas. if you
then smell gas, STOP! Follow “B” in the safety
gas, go to the next step.
7. Push gas control switch to “ON”.
NOTE: Do not force.
8. Replace control access panel.
9.Turn on all electric power to the appliance.
10.Set thermostat to desired setting
11.If the appliance will not operate, follow instructions
“To Turn Off Gas To Appliance” and call your
service technician or gas supplier.
FOR YOUR SAFETY READ BEFORE OPERATING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
SWITCH SHOWN IN
THE “OFF” POSITION
See Fig Instruction of lighting/ shutdown operation. Should the
gas supply fail to shut off or if overheating occurs, shut off the
gas valve to the furnace before shutting of the electrical supply.
Before heating season begins, exame the furnace to determine
that:
a. All flue gas carrying areas external to the furnace (i.e.
chimney, vent connector) are clear and free of obstructions.
b. The vent connector is in place, slopes upward and is
physically sound without holes or exccessive corrosion.
c. The return-air duct connection(s) is physically cound, is
sealed to the furnace casing, and terminates outside the space
containing the furnace. d. The physical support of the furnace is sound without sagging,
cracks, gaps, etc around the base so as to provide a seal
between the support and the base.
e. There are no obvious sign of deterioration of the furnace.
f. The burner flames are in good adjustment (by comparison with
pictorial sketches of the main burner flame (see Fig 31).
Furnace operation needs air for combustion and ventilation.
Do not block or obstruct air openings on furnace or spacing
arroud furnace required for supplying sufficient combustion air
and ventilation.