Krell Evolution e Series Manual - Manual (Page 23)

23
(SECTION THREE: Anatomy of an Evolution e Series Amplifier continued)
8 Backlight Control
Ext In. Connect a 12 V trigger to the Ext In input connector to turn off the power status
indicator (2) using a remote control. The switch must be set to On/Ext, in order for this
to function (see below).
On/Ext. This activates the power staus indicator. (This is the factory default position.)
Off. This turns off the power status indicator, during normal operation. The power status
indicator remains illuminated for ten seconds after the power buton is pressed.
Power
9 IEC Power Cord Receptacle
The power receptacle is for use with the provided 20 amp AC power cord. Use only the
power cord supplied with your Evolution e Series amplifier.
10 Power Breaker Switch
Place this switch in the up position to put the amplifier in stand-by mode. Place the
switch in the down position to turn off the amplifier.
continued