Reloop MIXAGE CE LTD. - Manual (Page 26)

ENGLISH
26
In the selection screen open the mapping file that is found on the CD or that was downloaded from
the Reloop support site.
Troubleshooting
Should a problem arise and Mixage´s LEDs are not lit correctly, this is probably caused in most ca-
ses by installed MIDI software (e.g. MidiYoke, Maple Virtual MIDI Cable, Bome, Osculator, etc.)
In order to solve the problem proceed as follows:
1. In Traktor open the adjustment dialogue by clicking the small cog wheel in the
upper right corner.
2. Open the category „Controller Manager“.
3. For the following device entries the following port assignments have to be configured:
4. OPERATION
After connecting and configuring Reloop Mixage correctly for the DJ software, Traktor can now be used.
NOTE!
In the following the whole Traktor function assignment will be described. Some features are only
available in Traktor Pro and therefore they have been marked grey in the following chart.
Device In-Port Out-Port
Mixage V* Reloop Mixage Reloop Mixage
Element Function Function with activated Shift -T3-
T1 Pitch Bend – Button
Allows the temporary deceleration (counter-
clockwise) of a track.
T2 Pitch Bend + Button
Allows the temporary acceleration (clockwise)
of a track.
T3 Shift Button
By pressing this button all the device‘s con-
trol elements receive a different function. The
current assignment can be viewed on the right
side of this chart.