Reloop MIXAGE CE LTD. - Manual (Page 29)

ENGLISH
29
5.1 MIDI ASSIGNMENT
NOTE!
By default Mixage is configured for MIDI channels 1 or 2. The MIDI channell can be selected via
the switch on the rear side -B43-.
It is possible to connect a further Mixage controller, i.e. for DJ teams. For this purpose it is important
that one Mixage is on MIDI channel 1 and the second Mixage is on MIDI channel 2 (see switch -B43-).
Reloop‘s official mappings are laid-out according to the standard configuration. Therefore changes
are usually unnecessary.
NOTE!
Updated and advanced mappings can also be found online. Go to http://www.reloopdj.com/forum
and open the category „Mapping Files“ under „Downloads for all Reloop products“.
5.2 LED FUNCTIONAL TEST
Herewith it is possible to check whether all of Mixage‘s LEDs work properly.
To carry out the functional test proceed as follows:
1. Make sure that Mixage is turned off (see position On/Off Button -B41-).
2. Press and hold the left Sync Button -T16- and turn on Mixage via the On/Off Button -B41-.
3. Now release the Sync Button -T16-.
4. Now all LEDs should be illuminated.
5. In order to finish the test, simply turn off the device via the On/Off Button -B41-.
6. UPDATES & SUPPORT
For Reloop Mixage it is possible to update its firmware. This way changes can be applied and new
features added subsequently. Instructions on how to proceed can be found online under the below
mentioned address.
Especially updated drivers for the integrated audio interface are offered which can be downloaded.
6.1 FIRMWARE CHECK
1. Turn off the device via the On/Off Button -B41-.
2. Press and hold the right Shift Button -T3-.
3. Turn on the device via the On/Off Button -B41-.
4. The firmware version is displayed via the Level LED Display -T32-.
Example: Left LED Display: 1 LED + right LED Display: 5 LEDs = Firmware version 1.5
6.2 FIRMWARE UPDATE
1. Make sure that Mixage is turned off (see position On/Off Button -B41-) and connected to the com-
puter via USB.
2. Press and hold the TRAX Encoder -T20- and turn on Mixage via the On/Off Button -B41-.
3. Now release the button -T20-.
4. The Power Status LED -T30- and the MIDI Status LED -T31- will now flash. Mixage is now in update mode.