Sound Devices 970 - Manual (Page 61)

970 User Guide
55
Se
tup Menu Op
tions
# Parameter Name Description Options
4 GPIO Inputs
Set GPIO inputs (pins 1, 2, and 3 on GPIO connector)
to active high or active low. Active high: Connecting
the pin to +5V will activate the function. Active low:
Connecting the pin to ground will activate the function.
» Active low
• Active high
5 GPIO Outputs
Set GPIO outputs (pins 6, 7, and 8 on GPIO connec-
tor) to active high or active low. Active high: When the
function is true, +5V will appear on the pin. Active low:
When the function is true, the pin will be grounded.
• Active low
» Active high
Network
# Parameter Name Description Options
1 This 970’s Name
Sets name of 970. This must be unique within a
network.
» 970
2 Grouping Sub-menu for network grouping settings.
2.1 Network Group
Groups with other PIX 250i, PIX 260i, PIX 270i, and
970 units on the network.
» No Group
• Group 1
• Group 2
• Group 3
• Group 4
2.2 Push Settings to Group
Copies this unit’s settings to all other units in the
group. All grouped settings will be pushed. ( See
“Grouped Settings”, page 46 )
2.3 Synchronize audio channel
settings
3 Dante Redundancy Mode
When On the 970’s Primary and Secondary Ethernet
ports both transmit Dante Audio over separate net-
works. This provides a fail safe of the Dante system if
one of the networks should fail. In Dante Redun-
dancy Mode, two separate networks must
be run and they CANNOT be connected to
one another. Connect any computer running
Dante Controller to the 970’s PRI Ethernet
network.
» Off
• On
4 Auto IP Settings
When On, the IP settings will automatically be pro-
vided by a DHCP (recommended), or Link-local when
no DHCP is present. When Off the IP Address, Subnet
Mask, and Gateway will have to be entered manually.
• Off
» On
5 IP Address
Displays IP Address, can be edited when Auto IP
Settings is OFF.
6 Subnet Mask
Displays Subnet Mask, can be edited when Auto IP
Settings is OFF.
7 Gateway
Displays Gateway, can be edited when Auto IP Set-
tings is OFF.
8 Authentication
Set the user name and password to be used for
PIXNET and Samba drive access.
» guest / guest
System
# Parameter Name Description Options
1 Power
Determines power on and off method. When set to
Always on, the 970 will turn on and off when external
DC is applied. When Use Power Switch is selected the
970 is powered on and off using a key combination of
AUDIO Button + Control knob press.
• Always On
» Use Power Switch