Sound Devices 702 - Manual (Page 58)

702 User Guide and Technical Information
56
v. 2.67 Features and specifications are subject to change. Visit www.sounddevices.com for the latest documentation.
Specific Setup
Menu options can
be programmed if
multiple options are
available.
If a single key or key combination is programmed for multiple shortcuts, the shortcut with the lowest
number will take precedence.
Shortcut List Functionality
The shortcut list is a user definable list of keyboard keys/Logic In that perform specified actions. The
actions that a keyboard key can perform are listed in the below table. Macros are not implemented.
Action Function
Momentary Button Logic Input Only. Simulates selected button. Can simulate in any menu
Toggle Button Logic Input Only. Toggles state of selected button. Play and Record are supported.
Open Menu Opens a SetupUI Menu
Cycle Settings Cycles a SetupUI parameter to the next setting and saves it
Set Settings Sets a SetupUI parameter to the given setting and saves it
Open Time Code Menu Opens the Time Code: Jam Menu and goes to the given parameter
Jam Time Code Item Jams given Time Code parameter
Edit Time Code Item Opens the Time Code: Jam Menu Edit screen for the given parameter
Button Shortcuts Simulates a front panel button shortcut. Ex: (Stop+Play) opens TakeList Menu
Logic Inputs and Outputs
Identical to shortcuts assigned to computer keyboard key sequences, the CL-1 has six contacts that
can be programmed to perform Setup Menu items or control the record, play, and stop functions of
the recorder. A switch connected between the assigned pin and ground (pin-7) will form a circuit.
Closing the circuit will activate the programmed action.
The Logic pins on the CL-1 can be set individually as either a switch-closure input or a switch clo-
sure output. The inputs and outputs are “logic low” devices, meaning that to turn “on” an input, it
must be connected to ground (zero volts). Likewise, when an output is “on”, it puts out 0 volts and
when it is “off”, it puts out +5 volts.
Logic Inputs
Configured as a switch-closure input, a pin can be connected to a switch that a user has wired to
assigned contact. This switch can then trigger the 702 to begin recording. Other functions can be as-
signed as well from the Setup Menu. The switch-closure on a given pin of the CL-1 can be thought of
as just another key on the keyboard. Anything that can be assigned to a key can also be assigned to a
switch.
To configure a pin as an input, navigate to EXT KEYBOARD ASSIGN in the Setup Menu. Select a new
SHORTCUT number, then locate the Login inputs amongst the assignable keys. Choosing LOGIC IN 1
would correspond to pin 1 on the CL-1, LOGIC IN 2 would correspond to pin 2 on the CL-1, and so
on. After a Logic input is chosen assign the desired action that the Logic input will control.