Sound Devices 702 - Manual (Page 59)

702 User Guide and Technical Information
57
Logic Outputs
Configured as a switch-closure output, the CL-1 can drive LEDs, relays, or any other sort of device
which will accept a TTL-level or similar input. For example, the CL-1 can drive a big red LED con-
nected via a series resistor between the +5V output and a switch-closure output and light up when-
ever the recorder is put into record mode.
To configure a pin as an output, go to CL-1: LOGIC OUT ASSIGN in the Setup Menu. The Logic
Pin number is on the left hand side (“00”, “01”, etc). Each of these pins can be assigned to un-
defined, Stop, Play, Record, or Pause. Note that if a pin is assigned to be both an input (via the
EXT KEYBOARD ASSIGN Setup Menu) and an output (via the CL-1: LOGIC OUT ASSIGN Setup
Menu), the pin will automatically default to an output.
702 Setup Presets
Presets are useful shortcuts to speed setting the numerous parameters available in the Setup Menu.
The 702 has four built-in presets and one user preset per media.
Built-In Presets
The 702 is shipped from the factory with the factory preset applied. Its settings are listed below.
Three additional presets, film, reporter, and music presets allow for quick setup of typical param-
eters for the defined application. Presets are applied by entering the Setup Menu and selecting the
preset. All previous settings are lost when a preset is applied.
702 Presets Factory Preset
Film
Preset
Reporter
Preset
Music
Preset
Rec: FireWire Connection External Drive External Drive Computer Connect Computer Connect
Rec: Sampling rate 48 kHz 48 kHz 44.1 kHz 44.1 kHz
Rec: Bit Depth 24 bits 24 bits 16 bits 16 bits
Rec: File Type .wav poly .wav poly .wav mono .wav poly
Rec: Media Select EXHDD and CF EXHDD and CF CF only CF only
Rec: Scene Name/Number None None None None
Rec: Track Names
Track A: Track A
Track B: Track B Track A: Track A
Track B: Track B Track A: Track A
Track B: Track B Track A: Track A
Track B: Track B
Rec: Take Name/Number T 01 T 01 T 01 T 01
Rec: Take Reset Mode When Scene is changed When Scene is changed When Scene is changed When Scene is changed
Rec: Pre-Roll Time 2 Sec 2 Sec 2 Sec 2 Sec
Rec: Dither Off Off On On
Rec: Timer Start Disabled Disabled Disabled Disabled
Rec: Timer Stop Disabled Disabled Disabled Disabled
Rec: Record Indicator Normal Numbers Normal Numbers Normal Numbers Normal Numbers
Rec: Record Pause Disabled Disabled Disabled Disabled
Input: Routing 1->A / 2->B 1->A / 2->B 1->A,B / 2->A,B 1->A / 2->B
Input 1: 48V Phantom Off On - Mic On - Mic On - Mic
Input 2: 48V Phantom Off On - Mic On - Mic On - Mic
Mic Inputs: Limiter Enabled Enabled Enabled Enabled
Mic Input 1: Low Cut Disabled Disabled Enabled Disabled
Mic Input 2: Low Cut Disabled Disabled Enabled Disabled
Mic Input 1: Low Cut
Frequency
40 Hz, 12 dB/oct 40 Hz, 12 dB/oct 40 Hz, 24 dB/oct 40 Hz, 12 dB/oct