Tweco Merlin 6000 Plasma Cutting CE Slave Power Supply - Manual (Page 27)

Manual 0-2603 4-1 OPERATION
SECTION 4:
OPERATION
4.01 Introduction
This Section provides a description of the Slave Power
Supply operating controls and procedures. Identification
of the Front and Rear Panel Controls is followed by oper-
ating procedures.
4.02 Functional Overview
The system is a high performance 50 to 150 amp plasma
cutting system which can cut most metals from gauge
thickness up to two inches. With a quick change of torch
parts, power supply can also be used for plasma arc goug-
ing. In its simplest form, a system consists of one Master
Power Supply, one Arc Starter Box and one Maximizer
300 Liquid Cooled Torch and leads connected.
With the addition of a Slave Power Supply or a second
Master Power Supply the system becomes a 100 to 300
amp plasma cutting system which can cut most metals
from gauge thickness up to three inches.
4.03 Front and Rear Panel
Descriptions
This sub-section provides specific functional descriptions
of the Power Supply front and rear panel operating con-
trols, indicators and connections. The Power Supply has
two main front panels and one rear panel. Each panel is
described in this sub-section as to the functions of the
connections, switches, and indicators.
A-01529
Control Front Panel
Lower Front Panel
Figure 4-1 Main Front Panels
A. Lower Front Panel
A-01530
1
3
2
Figure 4-2 Lower Front Panel
1. Work Cable Strain Relief
Strain relief to secure the factory installed work cable
and ring lug to the Power Supply.
2. Pilot Lead Strain Relief
Strain relief to secure the pilot lead to the Power Sup-
ply after it is installed.
3. Power Lead Strain Relief
Strain relief to secure the power lead to the Power
Supply after it is installed.