Tweco 6000GST Merlin Plasma Cutting CE Slave Power Supply - Manual (Page 29)

Manual 0-2653 3-11 INSTALLATION PROCEDURES
Coolant Reservoir
Filler Cap
Deionizer
Bag
Basket
Coolant Level Indicator
A-00872
Figure 3-14 Coolant Reservoir
4. Carefully pour enough of the supplied Thermal Arc
Torch Coolant into the reservoir to fill it to the FULL
mark on the rear panel.
5. Reinstall the reservoir coolant filler cap.
6. After the complete system has been installed do the
following procedure to make sure the coolant has been
pumped through the system (see NOTE):
NOTE
Depending on the length of the hoses ordered with
the system more coolant may need to be added af-
ter turning ON the system for the first time.
a. Turn the system ON.
b. After 30 seconds turn the system OFF (see
NOTE).
NOTE
DO NOT allow the pump to operate more than
for 30 seconds the first time the system is turned
ON.
c. Add more coolant and turn unit back ON for
another 30 seconds.
d. Repeat steps 'b' and 'c' unit the coolant level
no longer drops.
e. Turn ON the system and allow the pump to operate
for ten minutes to properly purge any air from the
coolant lines before using the system.
3.12 External Cable Connections
Depending on the options installed there are various cables to
be connected the Power Supply.
A. Optional RC 6010 Remote Control
For mechanized systems, the optional RC 6010 Remote Control
allows the operator to control all system functions from a re-
mote location. The control cable to interface the RC 6010 to the
Power Supply is available in various lengths (Refer to Appen-
dix 4, Typical Mechanized System Cable Interconnection Dia-
gram).
1. Connect the control cable to the receptacle marked RE-
MOTE CONTROL (J15) on the rear panel of the Power
Supply.
A-01765
Cable From
Remote Control
REMOTE
CONTROL J15
Connector
Figure 3-15 Remote Control Interface Connection
2. Connect the other end of the control cable to the re-
ceptacle marked PS (J37) on the rear panel of the re-
mote control.
NOTE
Refer to the RC 6010 Remote Control Instruction
Manual 0-2478 for more information on the
RC6010 Remote Control including CNC.