Tweco CutMaster 101 - Manual (Page 16)

INTRODUCTION 2-4 Manual 0-2852
2.05 Power Supply Options and Accessories
Section 6, Parts Lists, provides catalog numbers and ordering information.
A. Single-Stage Air Filter Kit
For use with compressed air shop systems. Filters moisture and particulate matter from the air stream to at least
0.85 microns. This filter increases performance and improves consumables parts life.
B. Two Stage Air Filter Kit
For use on compressed air shop systems. Filters moisture and contaminants from the air stream to at least 5.0
microns. This filter is pre-assembled at the factory and needs only to be installed on the power supply.
C. High Pressure Regulators
High pressure regulators are available. The regulators are used to set the proper compressed air pressure.
NOTE
Regulators should not be installed with In-Line Air Filters.
D. Extended Work Cable with Clamp
As an alternative to the standard 20 ft / 6.1 m work cable & clamp on the power supply, a 50 ft / 15.2 m work
cable with clamp is available.
E. Multi-Purpose Cart
Rugged steel cart on easy-rolling rear wheels and front-mounted swivel casters. Provides maximum mobility
for the power supply and can also serve as a display cart. Top shelf is 12" / 305 mm x 20" / 508 mm. Steel handle
is 30" / 762 mm high.
F. Automation Interface Kit
This kit allows the user to convert a non automated power supply for use as part of a fully automated system.
The kit includes an automation interface board, wiring harness, mounting hardware and instructions. The auto-
mation interface provides the basic start / stop and OK to move functions, and a switch selectable voltage
divider output. An external connector simplifies the connection to a CNC type cutting machine. CNC cables are
available in 25' / 7.6 m and 50' / 15.m lengths for use with this kit.
G. Vinyl Cover
Nylon canvas power supply dust cover with water resistant finish, large outer pocket for storing manuals or spare
consumables, and adjustable draw cord for tight fit.