Cutmaster 10mm – Tweco CutMaster 10mm User Manual
Page 44
Advertising
cutmaster 10mm
SERVICE
5-2
Manual 0-5074
A. Each Use
Check torch consumables for wear, replace if necessary.
WARNING
Shut off power before inspecting or removing torch parts.
NOTE
When operating the torch in a normal condition, a small amount of gas vents through the gap between the shield
cup and torch handle. Do not attempt to over tighten the shield cup as irreparable damage to internal components
may result.
Art # A-03409_AB
Large O-Ring,
Cat. No. 8-3487
Small O-Ring,
Cat. No. 8-3486
Electrode, Cat. No. 9-8215
Start Cartridge,
Cat. No. 9-8213
Shield Cup, Cat. No. 9-8218
Worn Electrode
Worn Tip
40 Amp Drag Tip, Cat. No. 9-8207
Advertising