Tweco Max 300 w-TD-750 - Manual (Page 28)

OPERATION 22 Manual 0-2557
4.07 Machine Torch Operation
A. Cutting With Machine Torch
The machine torch can be activated by remote control
pendant or by a remote interface device such as CNC.
1. Use a square to check that the torch is perpendicu-
lar to the workpiece to obtain a clean, vertical cut.
Rack and
Pinion Mounting
Assembly
Square
A-00660
Workpiece
Figure 4-6 Checking Alignment
2. To start a cut at the plate edge, position the center
of the torch along the edge of the plate (refer to
Figure 4-7)
3. The machine torch can be activated by the remote
operator control panel, remote control pendant, or
by remote interface device such as CNC. After a
two second gas purge, the pilot arc will start. The
pilot arc will stay on as long as the torch is acti-
vated.
4. With the pilot arc on, the main cutting arc will be
established when the torch is brought within 1/8 -
3/8 in (3 - 10 mm) of the workpiece. If the cutting
arc is interrupted and the torch is still activated,
as when cutting expanded metal, the pilot arc will
automatically restart (see Auto-Restart Options in
the Control & Power Components Operating
Manual). De-activating the torch will shut off ei-
ther the pilot or main arc, depending on the mode
of operation.
5. Cut with a standoff of 1/8 - 3/8 in (3 - 10 mm) from
the work. The torch should be held perpendicu-
lar to the workpiece while cutting. Start cutting
slowly and adjust cutting speed for optimum cut-
ting performance. Refer to Section 4.09, Recom-
mended Cutting Speeds, for typical cutting speeds
for various materials and material thicknesses.
B. Travel Speed
Proper travel speed is indicated by the trail of the arc
which is seen below the plate ( Figure 4-7). The arc
can be one of the following:
1. Straight Arc
A straight arc is perpendicular to the workpiece
surface. This arc is generally recommended for
the best cut using air plasma on stainless or alu-
minum.
2. Leading Arc
The leading arc is directed in the same direction
as torch travel. A five degree leading arc is gener-
ally recommended for air plasma on mild steel.
3. Trailing Arc
The trailing arc is directed in the opposite direc-
tion as torch travel.
A-00662
Standoff
Distance
Straight Arc
Trailing Arc
Leading Arc
Direction of Torch Travel
Shown with
Rack and Pinion
Mounting Assembly
Figure 4-7 Machine Torch Operation