Tweco 150 Ultra-Cut - Manual (Page 44)

Manual No. 0-4800 3-22 INSTALLATION
Preparation
1. Remove the screws securing the Cover Panel to the Module.
2. Carefully remove the cover from the module noting the attached ground wire. Remove the ground wire if
needed.
Art # A-06882
Gas Control Module Cover
Do not remove
Remove Ground
Wire
Cover Removal
N. Fiber Optic Cable Installation
1. Install the through-hole protector for the fiber-optic cable in the hole in connection panel on the back of the
Module.
2. Pass the fiber-optic cable connector through the hole in connection panel on the back of the Module. Pass
enough of the cable into the Module to allow the cable to loop upward as shown.
CAUTION
Avoid kinking, twisting, or bunching the fiber optic cable. The cable can be damaged by being forced
into tight-radius turns.