Tweco 300 XT Ultra-Cut Plasma Cutting System With Automated Gas Control - Manual (Page 58)

ULTRA-CUT 300 XT
3-3� INSTALLATION Manual 0-5305
Art # A-12059
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire
Cover Removal
3. Position the Arc Starter on a flat, horizontal mounting surface.
4. Use pre-drilled holes in at least two of the feet on the bottom of the Arc Starter to secure the Arc Starter to
the mounting surface.
Art # A-12060
Minimum 2