Ultra-cut 300 xt – Tweco 300 XT Ultra-Cut Plasma Cutting System With Automated Gas Control User Manual
Page 62
Advertising
ULTRA-CUT 300 XT
3-3�
INSTALLATION
Manual 0-5305
Art # A-12059
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire
3. The Arc Starter must be grounded; the grounding terminal is marked . Refer to the previous section for
grounding details.
Ground Cable
Art # A-04758
1 Nut and 1 Washer
Remain in Place
Torch Leads
4. Use a clamp to secure the Torch Lead Shield braid brass ring to the port on the Remote Arc Starter as shown.
Advertising