Ultra-cut 300 xt – Tweco 300 XT Ultra-Cut Plasma Cutting System With Automated Gas Control User Manual
Page 59
Advertising
ULTRA-CUT 300 XT
Manual 0-5305
INSTALLATION
3-35
Input Connections
1. Refer to the illustrations. Make the following input connections to the Arc Starter.
• Coolant Supply and Return Hoses (from HE-400 Heat Exchanger). Hoses and connectors are color-
coded; Red for Return, Green for Supply.
Coolant Supply and Return Hoses
(from power supply)
Art # A-12061
Supply
Return
Coolant Return (Red)
Coolant Supply (Green)
Art # A-12062
Green
Red
2. Refer to illustration. Connect the Pilot wire and Negative cables using a star washer on each.
NOTE
* Slave and Master refer to only those set ups using two power supplies in parrallel. Slave is not used
in single system operations.
Advertising