Tweco K4000 - Manual (Page 17)

4-1
SECTION 4: INSTALLATION
4.01 Installing the DC Welding Power Cable and Air Hose to the
Power and Air Connector
Models Part No. 61-065-006, 61-065-007, 61-082-008 and 61-082-009
Follow these instructions to connect the DC Welding Power Cable and Compressed Air
Line directly to the Power and Air Connector on the Torch Swivel Cable Assembly.
1. Remove the Torch and Cable Assembly from the carton and lay the assembly in a
straight and untwisted position on a workbench or floor.
2. Position the molded boot so that you have access to the four (4) screws as shown
in Figure 4-1.
Figure 4-1
3. Use a straight blade screwdriver to remove the four (4) screws. Lift the top half of
the molded boot away from the assembly.
Figure 4-2 Figure 4-3