Tweco K4000 User Manual
Page 19
Advertising
4-3
8. Lift the assembly away from the bottom half of the boot to securely fasten. Do not
allow the crimped lug to move while doing this final tightening step.
Figure 4-7
9. Thread the incoming Compressed Air Line with a 3/8” pipe threaded fitting into the
Power and Air Connector. This connection should be wrench tight.
Figure 4-8
10. Reposition the Cable Assembly with the DC Welding Power Cable and Air Hose back
in place in the lower half of the boot.
Figure 4-9
Advertising
This manual is related to the following products: