Tweco 201 ts Thermal Arc User Manual
Thermal arc, 161 stl operating, Manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- 0-5147-Ccr
- SECTION 1: SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION
- 3.01 Environment
- 3.02 Location
- 3.03 Electrical Input Connections
- 3.04 Electromagnetic Compatibility
- 3.05 Setup for Welding
- 3.06 STICK (SMAW) Setup
- 3.07 LIFT TIG (GTAW) Setup
- 3.08 HF TIG (GTAW) Setup (201 TS Only)
- 3.09 Victor Regulator
- 3.10 Leak Testing the System
- 3.11 When You Finish Using the Regulator
- 3.12 Storage of the Regulator
- SECTION 4:
OPERATION
- 4.01 Front Panel
- 4.02 Welding Current Control Explanation
- 4.03 STICK (SMAW) Electrode Polarity
- 4.04 Effects of Stick Welding Various Materials
- 4.05 GTAW Electrode Polarity
- 4.06 Guide for Selecting Filler Wire
- 4.07 Tungsten Electrode Current Ranges
- 4.08 Shielding Gas Selection
- 4.09 Tungsten Electrode Types
- 4.10 TIG Welding Parameters for Steel
- 4.11 Arc Welding Practice
- 4.12 Welding Position
- 4.13 Joint Preparations
- 4.14 Arc Welding Technique
- 4.15 The Welder
- 4.16 Striking the Arc
- 4.17 Arc Length
- 4.18 Rate of Travel
- 4.19 Making Welded Joints
- 4.20 Distortion
- 4.21 The Cause of Distortion
- SECTION 5: SERVICE
- APPENDIX 1: OPTIONS AND ACCESSORIES
- APPENDIX 1: OPTIONS AND ACCESSORIES
- APPENDIX 4: SYSTEM SCHEMATIC - 161 STL
- APPENDIX 5: SYSTEM SCHEMATIC -201 ts
- LIMITED WARRANTY
- WARRANTY SCHEDULE