02 install the push-pull interface board, 02 install the push-pull interface board -3, Push pull interface kit – Tweco SP SERIE PowerMaster User Manual
Page 21
Advertising
3-3
July 7, 2008
Push Pull Interface KIt
3.02 Install the Push-Pull Interface Board
A. Position the new PC-board with the new spacers over the mounting holes of the intermediate plate and
snap into place. Refer to Figure 3-4.
B. Connect the 2-pin plug with red and blue leads to the board at terminal X17. Refer to Figure 3-4.
Figure 3-4: Position the New PC-Board
C. Reconnect all plugs to the new PC-board. Note the designations at the board. Refer to Figure 3-5.
Figure 3-5: SP4000W Connector Overview
D. Replace the right side casing cover and screw its 7 Phillips-head mounting screws back in.
Advertising