02 install the push-pull interface board, 02 install the push-pull interface board -2, Push pull interface kit – Tweco SP SERIE PowerMaster User Manual
Page 28
Advertising
5-2
July 7, 2008
Push Pull Interface KIt
5.02 Install the Push-Pull Interface Board
A. Remove spacers (3) from the PC-board (1) and exchange them with the new spacers (2). Refer to Figure 5-3.
2
1
3
Figure 5-3: Remove and Replace Spacers in New PC-Board
B. Position the new PC-board with the new spacers over the mounting holes of the intermediate plate and
snap into place. Refer to Figure 5-4.
Figure 5-4: Position the New 400SP PC-Board
C. Connect the 2-pin plug with red and blue leads to the board at terminal X17. Refer to Figure 5-5.
Figure 5-5: Connect the Red and Blue Cable to New PC-Board
Advertising