Tweco FP-95 Mini MIG - Manual (Page 19)

INTRODUCTION FIREpOwER Fp-95
Introduction 2-3 Manual 0-5122
∆ The recommended time delay fuse or circuit breaker size is 20 amp. An individual branch circuit capable of carrying 30 amperes
and protected by fuses or circuit breaker is recommended for this application. Fuse size is based on not more than 200 percent
of the rated input amperage of the welding power source (Based on Article 630, National Electrical Code)
Thermal Arc continuously strives to produce the best product possible and therefore reserves the right to change, improve or
revise the specifications or design of this or any product without prior notice. Such updates or changes do not entitle the buyer
of equipment previously sold or shipped to the corresponding changes, updates, improvements or replacement of such items.
The values specified in the table above are optimal values, your values may differ. Individual equipment may differ from the above
specifications due to in part, but not exclusively, to any one or more of the following; variations or changes in manufactured
components, installation location and conditions and local power grid supply conditions.
2.07 Volt - Amp Curves
FP-95 FIREPOWER Vin=115V 60Hz
0
2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
OUTPUT CURRENT
OU
TP
UT
V
OL
TA
GE
Art # A-09068
Figure 2-1: Volt/Amp curves of the FirePower 95