Vixen SPHINX SXD Mount - Manual (Page 55)

Page 56
Procedures (for Windows)
(1) Download the latest firmware version from STARBOOK updates information to a
directory on your PC.
(2) Connect the STARBOOK and the PC with the LAN crossover cable.
*As for a connection of the LAN cable to the PC, please refer to the instructions for the PC.
(3) Turn on the STARBOOK.
(4) Turn on the PC.
(5) Wait for a period of one minute. The STARBOOK and PC acquire information on
networking automatically.
(6) In the STARBOOK menu, go into About STARBOOK. Write down the IP address &
Subnet mask numbers. Make a note of the version and build to compare with after the
update.
(7) Open the update program that you downloaded in (1). (e.g. Update32.exe)
(8) You should be at the update program screen. Enter the STARBOOK IP address as you
obtained at (6).
Click on the OK button.
(9) Wait for a couple of minutes until the message below appears on the screen. It shows
you that the update is finished successfully. Click on OK.
(10) Turn off the STARBOOK to reboot. Turn on the STARBOOK again. In the
STARBOOK menu, go into About STARBOOK. Confirm that the version and build are
changed.
(11) When the update is done, turn off the STARBOOK and disconnect from PC.