Weller 6966 HEAT GUN - Manual

6966 HEAT GUN
READ SAFETY INSTRUCTIONS ON
PAGE 3 BEFORE OPERATING HEAT
GUN.
OPERATION
1. Connect power cord to main AC outlet. (Do not use DC).
2. Place appropriate baffle over nozzle of gun before turning power
switch on.
3. The trigger power switch has three positions.
The Hot Air (II) position will produce air tem
perature at nozzle of approximately 800°F in
10 seconds. SWITCH TO COLD AIR 30-45
SECONDS BEFORE TURNING OFF. This will
increase the life of the heating element.
4. Keep nozzle at least 1/4" from the surface to be heated. Restricting the air flow from the nozzle may cause
damage to your heating element. CAUTION: Heat Gun should never be placed in a position where the
stream of hot air is directed onto table surfaces or flammable materials.
5. The Heat Guns may be operated in several positions.
1
Self-
Standing
Suspended With 6965A
Holder
6. To remove or change baffles when hot, simply trigger power switch to Cool Air position (I); hold handle of gun
in one hand and remove the hot baffle with a pair of long nose pliers.
HEAT GUN BAFFLE ACCESSORIES
6957
Shrink Tubing
Reflector
1 1/4" Reflector,
3/4" Diameter
For larger shrink-
ing applications.
6956
Shrink Tubing
Reflector
1/2" Reflector,
3/4" Diameter
Designed for general heat
shrinking applications.
6964
Precision Reflector
Designed for shrinking
miniature tubing and in-
sulators.
6958
Reducing Baffle
For critical heat direc-
tion. Reduces air flow
at nozzle to .200".