Weller 6966 HEAT GUN - Manual (Page 4)

4
VI. Motor and Scroll Assembly
a. For removal of motor and scroll assembly (10) follow steps 1 through 5 in Section II, and steps 1 through 5
in Section V.
b. Remove motor and scroll assembly (10) without disconnecting heating element with diode assembly (4).
c. Insert replacement motor and scroll assembly.
d. Resolder bare leads at solder joints (5) and (6). See CAUTION note, Section V, step 5.
e. Dress Wires (See Illustration)
f. Join left scroll half (11) with motor and scroll assembly (10) per step 9 in Section V.
g. Reassembly per Section III.
VII. Three Wire Cordset Assembly
a. Disassemble per Section II.
b. Remove center lead connector form center terminal on Switch (21).
c. Cut and remove plastic wire nut (15) on green
I. Replacemen t Part Numbers
120v
240v Description
168 168 Cone and Insulator
182 182G Heating Element with Diode Assembly
183K — Heating Element with Diode Assembly for Model 6966K
183 183G Motor and Scroll Assembly
185 185 Ferrule
187 187G 3-Wire Cord Assembly
120v 240v Description
187K — 3-Wire Cord Assembly for Model 6966K
188 188 Hot-Off-Cold Switch
189 189 Heat Gun Case
6956 6956 Shrink Tubing Reflector
6957 6957 Shrink Tubing Reflector
6958 6958 Reducing Baffle
6964 6964 Precision Reflector