Weller WSD80 - Manual (Page 4)

4
9
SETTING THE TEMPERATURE
The digital display (2) shows the actual value temperature. By pressing the UP or DOWN key (3, 4) the digital display (2)
switches to the set point. The set point (“flashing display”) can be changed by tapping or by firmly pressing the UP or
DOWN button (3, 4) in the desired direction. Pressing the button will change the set point quickly. The digital display (2)
returns automatically to the actual value approximately 2 seconds after releasing the button.
MAINTENANCE
The transition between the heating element/sensor and the tip of the soldering iron may not come in contact with dirt,
foreign particles or become damaged, since this affects the precision of the temperature control.
INSTRUCTIONS FOR USE
For initial heating, coat the selective tinnable tip with solder. This removes any oxidation or dirt on the tip, which may have
occurred during storage. During pauses between soldering and before storing the soldering iron, ensure that the tip of the
soldering iron is well coated. Do not use aggressive fluxing agents.
Note: Always ensure the proper position of the soldering iron tip. When removing tip (HOLD TIP DOWN)!
These soldering irons have been adjusted for an average-size tip. Deviations can occur due to exchanging of the tip or using
other tip designs.
20. Attention.
Use only accessories or attachments which are listed in the accessories list of the Operation Manual. Use only
WELLER accessories or attachments on original WELLER equipment. Use of other tools and other accessories
can lead to danger of injury.
21. Repairs to your soldering tool should be carried out by a qualified technician.
This soldering tool is in accordance with the relevant safety regulations. Repairs should only be carried out by a
qualified electrician using original WELLER replacement parts. Failure to do so can lead to accidents for the
operator.
22. Do not work on electrically live parts.
The grip of antistatic designed soldering tools is conductive.
23. Applications with other WELLER equipment.
If the soldering tool is to be used together with other WELLER equipment and attachments, also observe the
warning notices given in the corresponding Operation Manual.
24. Observe the valid safety regulations for your workplace.