Weller WXMT - Manual (Page 22)

8-10 WXMP/WXMT
Replacing a used soldering tip
1. Place the soldering tool into the safety rest.
2. Switch off the supply unit.
3. Wait three minutes until the soldering tip has cooled off.
4. Hold the soldering iron by the handpiece and pull the soldering tip
off of the tool by the tip handle (3).
CAUTION! Danger of malfunction
The soldering tip must be inserted completely.
Use of a soldering tip that has not been fully inserted can cause
the tip to malfunction.
Z
For this reason, make sure that the soldering tip is inserted as
far as it will go in a single motion.
Inserting a new soldering tip
5. Hold the soldering iron by the handpiece (4) and insert the tip into
the soldering tool by the tip handle (3).
6. Switch on the supply unit and set the required temperature.
Note If different types of soldering tip are used, it is recommended that
the tips be placed into the metal sockets provided on the back of
the WDH 50 rest.
7 Changing the WXMT tip cartridges
WARNING! Risk of burns
The tips become very hot during soldering and desoldering.
There is a risk of burns from touching the tips.
Z
The tweezers must be switched off and stand at least 3 min. in
the safety rest (WDH 60) until the soldering or desoldering tips
have cooled off. Soldering/desoldering tips may only be
replaced after they have cooled off.
Replacing used tip cartridges
1. Place the tweezers into the safety rest.
2. Switch off the supply unit.
3. Wait three minutes until the soldering/desoldering tips have
cooled down.
4. Hold the desoldering tweezers (4) by the handpiece and pull the
tip cartridge (3) out of the handpiece by the recessed handles.
CAUTION! Danger of malfunction
The tip cartridge must be inserted completely.
Use of a tip cartridge that has not been fully inserted can cause
the tip cartridge to malfunction.
Z
Make sure that the tip cartridge is inserted as far as it will go in
a single motion.