Wildview STC-TGL-3 - Manual (Page 19)

STC-TGL3M
www.wildviewcam.com Toll Free 888-304-6125 19
• When you have completed the testing the coverage
area open the front housing and slide the power
switch from Test position to PIR position. Front LCD
counter will show “0000”. The camera will enter
count down mode for 1 minute and front green
indicator will start blinking giving you one minute to
leave the coverage area. Then camera will enter PIR
detection mode.
NOTE: Make sure you slide the power switch from TEST
mode to PIR mode before you leave the field. Otherwise
the Camera will not take any pictures.
Switch use: Do not move the switch from TEST directly
to PIR. Doing so will cause the camera to not operate.
Slide the switch to OFF. Wait for the front LCD screen to
turn off then continue to slide the switch to PIR.