ClearOne PAN6400 User Manual
Page 23
Configuring Standalone Installations
3-5
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
complete wiring diagram for this configuration. For more detail on the ports on the rear
panel of the Panorama, see
Figure 3-3
S-Video and coaxial digital (S/PDIF) audio
To make the connections for S-Video and digital audio, complete the following steps:
1.
Ensure power is off to all devices.
2.
Connect the S-Video cable (provided with the source) from the source to the
S-Video adapter (provided) and connect the blue (Pb) and red (Pr) RCA
connections to the PAN6400 VDC IN ports for that source.
3.
Connect the coaxial digital (S/PDIF) cable from the source to the PAN6400 VDC
IN port (green) for that source.
4.
Connect an IR Emitter to the PAN6400 VDC IR OUTPUT port for that source and
place the emitter end over the IR window on the front of the source.
5.
Connect the CAT5 cable from the room output on the PAN6400 VDC to the VIM
port of the VP700.
6.
Use an S-Video cable to connect the VP700 to the display.
You can also route the video from the VP700 to an A/V Receiver and then to the
display.
7.
Connect the Y/Composite port of the VP700 to the Digital Audio In of the A/V
Receiver.
Legend
IR Emitter
CAT5
S-Video
Coaxial audio
Speaker
5.1 or higher
channel speaker outputs
Display
PANVP700
Back
IR
Receiver
PANVP700
Front
PAN6400
IR
Emitter
Source
This configuration does not
work for component video.
w
e
r
t
y
u
i
o
a