ClearOne PAN6400 User Manual
Page 28
NetStreams Panorama System Installation Guide
3-10
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
8.
Connect the Ethernet CAT5 cable from the room output for the source on the
PAN6400 VDC (1) to the VIM port of the VP700 you are using to connect to a
display.
9.
Use an S-Video cable to connect the VP700 attached to the PAN6400 VDC (1) to
the display.
You can also route the video from the VP700 to an A/V Receiver and then to the
display.
10.
Connect the Y/Composite port of the VP700 attached to the PAN6400 VDC (1) to
the Digital Audio In of the A/V Receiver.
11.
Connect the Ethernet CAT5 cable from the room output for the source on the
PAN6400 VDC (2) to the VIM port of the VP700 you are using to connect to a
display.
12.
Use an S-Video cable to connect the VP700 attached to the PAN6400 VDC (1) to
the display.
You can also route the video from the VP700 to an A/V Receiver and then to the
display.
13.
Connect the Y/Composite port of the VP700 attached to the PAN6400 VDC (1) to
the Digital Audio In of the A/V Receiver.
14.
Connect the IR Receiver supplied with the VP700 that is attached to the PAN6400
VDC (1) to the IR IN port on the VP700 and place the IR Receiver dome where it
can receive an IR signal from the remote. See
Panorama Video Ports: PANVP500
on page 2-5 for information on effective IR Receiver placement.
Repeat for each VP700.
15.
Connect an IR Emitter to the IR Out port of the VP700 attached to the PAN6400
VDC (2) and place the emitter end over the IR window on the display.
Repeat for each VP700.
16.
Connect 5.1 or 7.1 channel speakers from the output ports of the A/V Receiver.
Repeat for each A/V Receiver.
17.
Turn power on to all devices.