Wheatheart X13 Power Swing - Manual (Page 25)

W HEATHEART - P OWER S WING M ANUAL 4. M AINTENANCE & S TORAGE
E LECTRIC AND H YDRAULIC 4.1. M AINTENANCE P ROCEDURES
30802 R0 25
4. Maintenance & Storage
4.1. MAINTENANCE PROCEDURES
Please follow the guidelines below.
Area Maintenance Procedures Frequency
General While auger is in use, observe the pre-operational checklist on
page 21 of the Operation section. Daily
General Check all operating, lifting, and transport components. Replace
damaged or worn parts before using auger.
For replacement instructions, see the Assembly section of this
manual.
Regularly
Drive
Chain Keep drive chain tension adjusted to about 1/4” deflection by
loosening the 2 bolts on the hydraulic or electric motor mount,
then re-tighten.
• Apply the same procedure to the chain between the wheels.
• The tension for the inter-wheel drive chain is adjusted by
loosening the two bolts on the wheel adjust plate; re-tighten
when finished.
• Oil chain frequently enough to keep a light film of oil on it.
• Ensure that safety guards are in place and secure before
operation.
Frequently
Hydraulic
Hose Check hose and hose couplers for leaks, wear, or damage.
Replace if necessary.
• Use cardboard when searching for hydraulic leaks.
Frequently
Remote
Transmitter Ensure that a 9V battery is installed in the back of the remote
transmitter. To install:
• Remove the plastic from around the battery.
• Then place the battery into the back of the remote control.
For proper replacement procedure, refer to Figure 5.1 in the
Appendix section of this manual.
Before initial
operation, or
as required
Tire
Pressure Check with a pressure gauge. It is recommended that pressure
be maintained at a maximum of 28 psi (193 kPa). Monthly, or
as required