Wheatheart Swing Away Auger (10 & 13) - Manual (Page 20)

4. O PERATION W HEATHEART - SA A UGERS
4.2. O PERATOR C ONTROLS SA 1061, 1071, 1081, 1091, 1371, 1381, 1391
20 30582 R7
4.2. OPERATOR CONTROLS
The hopper winch is located as shown in Figure 4.1. The hydraulic shut-off valve
is located as shown in Figure 4.2. Please refer to the tractor manual for hydraulic
and PTO controls.
4.3. PRE-OPERATION
4.3.1. C HECKLIST
• Tighten all fasteners.
• Adjust and/or lubricate boot chain and hopper chain.
• Ensure auger rotates freely.
• Check that tire pressure is within the manufacturer’s specification.
• Ensure wheel bolt torque is within specification .
• Check hopper winch cable for damage (fraying, kinking, unraveling). Replace
as required.
• Ensure cable anchor on the winch drum is tight.
• Check gearbox oil levels.
• Grease and clean machine if needed.
• Ensure hydraulic system is functioning, is free of leaks, and the hoses are not
pinched or kinked.
• Check that truss cables are free from damage (fraying, kinking, unraveling).
The cables must be tight and properly adjusted for proper auger tube align-
ment.
• Ensure PTO shaft is properly installed.
Figure 4.1 Winch Location Figure 4.2 Shut-off Valve