Wheatheart WHR 130 x 31-36ft Augers PTO-SD - Manual (Page 21)

WHEATHEART - GHR130 & WHR130 GRAIN AUGERS 3. A SSEMBLY
PTO-SD & EMD D RIVE M ODELS 3.7. D RIVESHAFT S HIELD
16652 R1 21
3.7. DRIVESHAFT SHIELD
Before installing the driveshaft shields, refer to Table 3.1 for the proper sequence
for your particular auger. Install shields working from the gearbox assembly up to
the discharge end.
To install:
1. Place driveshaft shield
against gearbox and over
chain coupler guard, then
secure with a guard strap and
2 self-tapping screws (Figure
3.6).
2. To install remainder of the
driveshaft shielding, work
from the bottom up. Shields
should overlap at bearing support brackets (Figure 3.9).
Note:
When installing driveshaft shielding, refer to step 1 in Table 3.1.
3. Fasten with shield strap and self-tapping screws. Do not tighten until all
shielding is in place.
When using an electric motor:
• The motor and controls should be installed by a qualified electrician in
accordance with all local and national codes.
• Incorporate a magnetic starter to protect the motor.
• The motor must have a manual reset button.
• Locate reset and starter controls so that the operator has full view of the
entire operation.
• Locate main power disconnect switch within reach from ground level to
permit ready access in case of an emergency.
• A main power disconnect switch capable of being locked (in the off posi-
tion only) must be provided.
Figure 3.9
Table 3.1 Driveshaft Shielding Sequence
STEP
13” x 31’ SD 13”x 31’ EMD
QTY LENGTH QTY LENGTH
1 1 42" (1.07 m) 1 42" (1.07 m)
2 6 48" (1.22 m) 4 48" (1.22 m)
3 - 42" (1.07 m) 1 42" (1.07 m)
STEP
13” x 36’ SD 13” x 36’ EMD
QTY LENGTH QTY LENGTH
1 1 42" (1.07 m) 1 42" (1.07 m)
2 6 48" (1.22 m) 4 48" (1.22 m)
3 1 60" (1.52 m) 1 60" (1.52 m)