Wheatheart WHR 130 x 31-36ft Augers PTO-SD - Manual (Page 23)

WHEATHEART - GHR130 & WHR130 GRAIN AUGERS 3. A SSEMBLY
PTO-SD & EMD D RIVE M ODELS 3.9. T RANSPORT U NDERCARRIAGE
16652 R1 23
e. Tighten slotted spindle nut until hub drags slightly. Back off nut about 1/4
turn until hub turns freely.
f. Install cotter pin and dust cap.
Note:
Installing tires may not leave you with enough clearance to position and attach
undercarriage once auger tube is raised. If so, install wheels after assembly is
complete.
g. Check that pressure of pre-inflated tires matches pressure indicated on tire
sidewall. Mount wheels on hubs and attach with six 1/2” x 1-3/4” wheel
bolts.
Figure 3.12
5. Fasten upper lift arms to lower reach arms with 3/4" x 2" bolts and locknuts.
Do not over-tighten. Tighten snug only; these bolts act as pivot points.
6. Raise the discharge end of auger with a
front end loader and a strong sling/chain or
block and tackle. The height should be
sufficient to clear undercarriage assembly.
7. Position transport undercarriage beneath tube assembly and attach lower
reach arms to mounting bracket on bottom tube with 3/4" x 2" bolts and
locknuts sandwiching the stabilizer brackets between as shown in Figure
3.13. Do not over-tighten. Tighten snug only as these bolts act as pivot
points.
WARNING
Do not remove tube support until auger is fully
assembled.