Great Plains PD8070 Operator Manual - Manual (Page 33)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 29
2014-07-23 Table of Contents Index 401-479M
Parking
1. Park planter on a level, solid area.
2. Place jack on stob on the side of the planter tongue.
Lower jack until weight of planter is off of tractor
draw bar. Remove hitch pin and safety chain.
3. Disconnect any hydraulic hoses from tractor. Do not
let hose ends rest on the ground.
Storage
Store planter in a clean, dry place with all tires out of the
sun. Store planter where children do not play. If possible,
store planter inside for longer life.
1. Thoroughly clean planter, hoppers, and meters.
Remove any dirt and debris that can hold moisture
and cause corrosion. See “Material Clean-Out” on
page 63.
2. Remove meters from hoppers. Disassemble meters
and inspect for wear. See “Seed Meter Setup and
Adjustment” on page 52. Make any repairs required
at this time. Blow excessive debris from meter. Wash
meters with mild soap and water. Dry meters and
spray a light coat of rust inhibitor on meters.
Reassemble and store meters in a dry place.
3. Thoroughly flush any treatment system with clean
water. Disconnect from tractor and completely drain
all lines and components to prevent damage from
freezing.
4. Inspect planter for worn or damaged parts. Make
repairs and service during the off season.
5. Use paint to cover scratches, chips, and worn areas
on the planter to protect the metal.
6. Adjust all drive chains for proper tension.
7. Lubricate planter at points listed under “Lubrication
and Scheduled Maintenance” on page 81. Be sure
to lubricate chains to prevent rusting.
8. Grease exposed portions of cylinder rods to prevent
rust. Be sure to remove grease prior to next
operation to prevent seal damage.
9. Place closing wheel handle in the middle slot to
relieve tension on closing wheels. Move T-handle for
opener springs to the lightest setting.
10. Cover planter with a tarp if stored outside.