Great Plains Electronic Acremeter (DataTrac) Assembly Instructions - Manual

Great Plains Mfg., Inc.
Operation/Installation Instructions 1
© Copyright 2013 Printed 2013-06-19 152-325M
Electronic Acremeter
Great Plains Drills
Used with:
• Most Great Plains Drills
*
General Information
These instructions explain how to install and use an
Electronic Acremeter.
These instructions apply to an installation of:
Consult your Great Plains dealer for specific ordering
information. The meter is factory programmed for
specific revolutions and units, and provides accurate and
easy-to-use readings only on a drill with matching
operating characteristics.
The meter is supplied with a decal indicating the factory
configuration. Placing it on a drill for which it was not
programmed will produce unsatisfactory results.
Each acremeter upgrades one drill.
Tools Required (if not installed)
• basic hand tools
* The electronic acremeter is compatible with all drills having a main or transfer drive shaft with at least one 1/2-20 tapped
hole in either end of the shaft on any section of the drill. The shaft must be before any Drive Type, gearbox, lower, range,
transmission or upper variable sprockets, and have only fixed sprockets and chains between the drive wheel and the shaft.
Kit Product Description
891-419C DATATRAC ACRE METER
Figure 1
DataTrac Electronic Acre Meter
34937