Great Plains UT5036 Disk Assembly Instructions - Manual

Assembly Instructions for the Ultra-Till
2/26/04
Thank you for purchasing the Great Plains Ultra-Till. To finish assembly you must first mount
the tires to the inside wings. Mount the tires as shown in layout (Inside Wing Wheel Assembly.) The
hub assemblies with the smaller titan tires pre-mounted get pinned on the caster wheel assemblies as
shown in layout (Caster Wheel Assembly – UT5042, UT5048, UT5052 ONLY.)
Then you must locate the correct coulter/disc gang assembly. The assembly should come to you
with a part number written on the gang. Simply match the part number on the gang frame with the
number located on the respective assembly layout and assemble as shown on the coulter/disc gang set-
up.
The next step is to start assembling the ball joint brackets on the phoenix module, so they can be
hung on the Ultra-Till frame. Assemble ball joint brackets as shown on (Phoenix Module Assembly.)
Leave all the nuts loose so the ball joint bracket can slide on phoenix module. On the end of the phoenix
module there is a number written in white paint. This will assist you in location of these modules.
Simply match the number on the side of the phoenix module to the number given in the respective
layout and assemble accordingly. Once phoenix module is hung tighten nuts on ball joint bracket to the
x dimension given for each individual module. This will place the phoenix modules in the correct
location and alignment. Once this is done, double check the machine with the layouts provided and
make sure there is no interference. This should complete the assembly of your Great Plains Ultra-Till.