Great Plains 1007NT Assembly Instructions - Manual

Great Plains Mfg., Inc.
Installation Instructions 1
©Copyright 2008 Printed 10/10/2008 202-582M
Native Grass Rate Reduction Kit
Great Plains 706NT/1006/1007NT No-Till Drills
Used with:
• All model year pull-type 706NT and 1006NT
a
drills,
with Series I or Series II Native Grass
• All 1007NT drills with Native Grass
General Information
These instructions explain Native Grass Rate Reduction
Kit installation. This feature supports lower Native Grass
rates than are possible with the standard drill. Each kit
converts an entire drill.
These instructions apply to:
Tools Required
• Basic hand tools, including snap ring pliers
• Chain oil
Before You Start
Refer to Figure 1
Remove all contents of the kit case (the case is used to
receive parts removed from the drill).
1. Inventory the new parts per “Parts List” on page 6.
Refer to the drill Operator Manual for these steps:
2. Hitch the drill to a suitable tractor.
3. Move the drill to a dry well-lighted location suitable
for disassembly.
4. Lower the drill.
5. Disconnect hydraulic and electrical power to the drill.
Note: Whenever mounting a
chain, make sure the clip at
the removable link is ori-
ented to minimize snags.
Install clip with open end
facing away from direction
of chain travel (shown by
gray arrows in chain routing
diagrams).
Notations and Conventions
a. 3-Point model 3P1006NT uses Rate Reduction kit 202-580A.
Kit Product Description
202-581A Native Grass Rate Reduction Kit
Figure 1
Kit Storage Case
28377
“Left” and “Right” are facing in the
direction of machine travel. An orienta-
tion rose in the line art illustrations
shows the directions of: Up, Back, Left,
Down, Front, Right.
to callouts identify components in the currently
referenced Figure or Figures. These numbers
may be re-used from page to page.
to document-wide callouts reference existing
parts exchanged or temporarily removed. The
descriptions match those in a current drill
Parts Manual.
to document-wide callouts reference new parts
from the list on page 6. The descriptions
match those on the cartons, bags or item tags,
as well the current Parts Manual.
U
D
F
B
L
R
1 9
11 22
51 58