Great Plains CPH-20 Predelivery Manual - Manual (Page 5)

3
Section 1 Assembly
12/28/05 CPH Center Pivot Hitch 148-152Q
Great Plains Mfg., Inc.
Section 1
Assembly
The following headings are step-by-step instructions for
assembling the center pivot hitch. Begin with Tools Re-
quired and Pre-Assembly Checklist to make sure you have
all necessary parts and equipment. Then proceed with As-
sembling Center Pivot Hitch. Follow each step to make the
job as quick and safe as possible and produce a properly
working machine.
The center pivot hitch is shipped via flat bed truck. It is the
dealer’s responsibility to unload the new machine. Unload
all equipment before beginning assembly. Do not attempt
any assembly work while the center pivot hitch is on the
truck.
Tools Required
•
Forklift or overhead hoist
•
General hand tools
Pre-Assembly Checklist
1. Read and understand “Important Safety Informa-
tion” on page 1 before assembling.
2. Have at least two people on hand while assembling.
3. Make sure the assembly area is level and free of ob-
structions (preferably an open concrete area).
4. Have all major components.
5. Have all fasteners and pins shipped with the hitch
IMPORTANT: If a pre-assembled part or fastener is
temporarily removed, remember where it goes. Keep
the parts separated.
.
6. Have a copy of the parts manual on hand. If unsure of
proper placement or use of any part or fastener, refer
to the parts manual.
7. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
8. Check for proper tension and alignment on all drive
chains.
9. Check that all safety decals and reflectors are correct-
ly located and legible. Replace if improperly located or
damaged. Refer to Safety Decals, “Important Safety
Information” in the operator’s manual.
10. Inflate tires to recommended pressure as listed on the
Tire Inflation Chart on the “Appendix” on page 7.
Tighten wheel bolts as specified on Torque Values
Chart on the “Appendix” on page 7.