Great Plains Yield-Pro 1625 Planter 2004 - Manual (Page 9)

12/12/2005 402-188M
Great Plains Mfg., Inc.
9 Installation Instructions
Replace Transport Support Hook Weldment
Refer to Figure 15
NOTE: To replace transport support hook weld-
ments, make sure the planter is unfolded. Failure to
unfold planter may result in injury or damage to the
machine or mechanic.
1. Remove one 3/8 x 2 1/2 roll pin from pivot shaft.
2. Slide transport pivot shaft from weldment. Re-
move and discard weldment and spring from
toolbar. Keep roll pins and pivot shaft for reuse.
3. Replace weldment and spring with new weld-
ment and spring provided in kit.
4. Replace pivot shaft and repin hook to toolbar us-
ing 3/8 x 2 1/2 roll pins.
5. Repeat steps on opposite side of planter.
Weldment
Roll Pin
Pivot Shaft 24002
Figure 15
Transport Support Hook Weldment
Install Hose Wrap and Cable Ties
Refer to Figure 16
1. If not cut already, cut spiral hose wrap in four
pieces. One piece will measure 4 foot, one piece
will measure 3 foot, and the remaining two piec-
es will measure 1 foot each.
NOTE: When wrapping hoses, only fertilizer
hose may be left out of hose wrap.
2. Using the 3 foot section, wrap all hydraulic lines
and electrical harness lines between left-hand
side toolbar/wing and center mainframe.
3. Start wrapping directly below fold cylinder rod
pin. Continue to wrap hoses up to the hose guide
on the toolbar pivot pin.
4. Using the 4 foot section, wrap all hydraulic lines
and electrical harness lines between right-hand
side toolbar/wing and center mainframe.
5. Start wrapping directly below fold cylinder rod
pin and continue to wrap beyond the hose guide
to control the hoses going on to the fan.
23421
Figure 16
Spiral Hose Wrap
Refer to Figure 17
6. If fertilizer hose is left out of hose wrap, route fer-
tilizer hose along front of the hydraulic lines
crossing below tongue. All hoses must be routed
through hose clips forward of opener mounts to
avoid piniching when the wings flex up and
down.
Figure 17
Fertilizer Hose