Great Plains 1007NT-1906 Assembly Instructions - Manual (Page 2)

2 Great Plains Manufacturing, Inc. Front Page Part Lists Caster Brace Update
151-169M Front Page Part Lists 08/21/2009
Before You Start
Compatibility
Refer to Figure 2 on page 1
1.
Verify from the serial number plate that the drill is the
model number (1007NT) compatible with this kit.
1. Check the gap where the caster weldments mount
on the frame cross-tube. Newer drills already have a
brace plate installed in gap
and do not need this
kit.
Refer to Figure 3
2.
Clean the inside and outside surfaces of the general
installation area.
3. Inspect the weld fillets at points , , and , on
both sides of and inside the weldment.
IMPORTANT !
If any welds are cracked, do not install the kit.
Have your dealer contact Great Plains for further
assistance.
4. Inspect the general condition of the caster weldment
side plates. Perform a trial alignment of the brace
plate, as per step 15 through step 20 on page 5. Do
not mark the hole locations at this time.
IMPORTANT !
If the plate cannot lie flat against the weldment, or the
hole locations would not meet the center-line require-
ment of step 14, do not install the kit. Have your
dealer contact Great Plains for further assistance.
Inventory
5. Make sure all parts are present (page 7).
Comprehension
6. Review these instructions. Make sure the installers
understand where each part or assembly is installed,
and what tools are required for the task.
Note: Illustrations in this manual, based on the parts
manuals for this family of drills, may show
exploded views that are fully disassembled. Rely
on the instructions for required disassembly and
reassembly steps.
Figure 3
Inspect Caster Weldment
29713
1
2
3
4
5
U
D
B F
1
2 3 4 5