Great Plains ADC1150 Parts Manua - Manual (Page 59)

Revision Comments Part Description Part No. Ref.
Image No. dwg19358
KNOB, TRANS. SHIELD 817-131C 1.
GUARD AUGER DRIVE CHAIN 817-376C 2.
NUT NYLOCK JAM THIN 3/8-16 PLT 803-215C 3.
CHAIN RL #50 37 PITCHES 136-148D 4.
SPKT 50B19 X 1 BORE 808-006C 5.
803-206CCOUPLER 3/8-16 X 1 3/4 803-201C 6.
SPKT 50B15 X 1 BORE 808-004C 7.
PIN ROLL 5/16 X 2 1/4 PLT 805-029C 8.
RHSNB 5/16-18X1 GR5 802-282C 9.
HYD MOTOR 7/8 ORBF 810-267C 10.
BRG INS 1.00IDX2.04OD SPH 822-060C 11.
HHCS 3/8-16X1 GR5 802-017C 12.
WASHER LOCK SPRING 3/8 PLT 804-013C 13.
WASHER LOCK 7/16 PLT 804-014C 14.
FLANGETTE 52 3-BOLT PLT 822-175C 15.
AUGER DRIVE MOTOR PLATE 166-561D 16.
AUGER HEAD STUB SHAFT 166-562D 17.
NUT LOCK 3/8-16 NYLON INSERT 803-078C 18.
HHCS 3/8-16X1 3/4 GR5 802-023C 19.
6 IN - 90 DISCHARGE SPOUT 6514A1 20.
NUT HEX 5/16-18 PLT 803-008C 21.
WASHER LOCK SPRING 5/16 PLT 804-009C 22.
HHCS 5/16-18X2 FTHD 802-473C 23.
DISCHARGE BANK BACK - 6 IN 50279A1 24.
WASHER FLAT 5/16 SAE PLT 804-036C 25.
HHCS 5/16-18X1 1/4 GR5 802-010C 26.
EL 3/4FJIC 3/4MJIC 811-150C 27.
AD 3/4MJIC 7/8MORB 811-192C 28.
NUT HEX 5/16-18 PLT 803-008C 29.
08/16/12 - 59 - 167-101P Rev. A__________
Table of Contents Part Number Index
Auger
Auger Hydraulic Drive (Part 2)
(Applies to ADC1150 (1998+) only)