Insert shaft – Great Plains 1005NG User Manual
Page 5
Great Plains Mfg., Inc.
Installation Instructions
5
02/29/2008
202-612M
Insert Shaft
16. Select one new:
or:
Note that one end has a hole for the sprocket pin
and the other does not.
17. Select two new:
118-494D LOCK COLLAR 3/4 HEX BORE
18. Insert the solid (no hole) end of the shaft
into the bearing at the drive side of the box.
19. While holding it level, slip a lock collar
solid end of the shaft.
20. Continue inserting the shaft through the new bear-
ing(s) in the partition.
21. Before inserting the shaft through the right end
bearing, slip another lock collar
onto the shaft.
Stop the insertion process at this point.
22. Select one new:
202-479H AGITATOR SPROCKET WELD-
MENT
and one used:
PIN LINCH 1/4 X 1 3/4 PLT
23. At the pinned end of the shaft
sprocket
on the shaft (raised hub facing out),
and insert pin
. Resume inserting the shaft in
the seed box.
24. Insert the solid end of the shaft through the new
bearing in the right end of the box.
25. Adjust the position of the shaft
teeth of the sprocket
ing, driven and idler sprockets of the Native Grass
drive.
26. Select four new:
801-035C SCREW SET 5/16-18 SKT KP X 3/8
27. Without disturbing the position of the shaft
,
slide the left lock collar
bearing.
28. Insert two set screws
29. Slide the right collar up against the right end bear-
ing. Insert two set screws
and secure the collar.
Figure 9
Shaft Insertion
26288
60
U
D
L
R
B
F
13 14
60
13 14
60