Great Plains 1005NG - Manual (Page 6)

Great Plains Mfg., Inc.
6 Hex Shaft Update Kits
202-612M 02/29/2008
Closeout
30. Gently tighten the bolts of the left side flangette
while rotating the new sprocket.
31. Do the same for the right end flangette, and then the
partition flangettes.
32. When all are tightened, make sure the shaft rotates
freely.
33. Install any new agitators at this time, per the instruc-
tions included with the agitator kit. That installation
does not require shaft removal.
34. Remount the drive chain, engage the idlers, and
adjust for
1 ⁄
2
in slack in the longest span.
35. Reinstall access panels and close snaps.
Note: No seed rate adjustments result from this shaft
update alone. Other kits that update your drill to
Native Grass II may require a new seed rate man-
ual.