Great Plains DICKEY-john IntelliAg Planter-Drill Control L1 - Manual (Page 18)

OPERATOR’S MANUAL
IntelliAg PDC User Level 1 (GP)
11001-1508-200903
16 / SYS INFOR AND DIAGNOSTICS
2. If the Disable Manual Valve button is displayed, the selected channel
has already been enabled for manual valve position operation.
3. Set the Master Switch to the ON position.
4. Press the Increment button to open the channel’s valve. The Channel
Pulse Width Modulation (PWM) data item displays the current PWM
signal that is being output to the valve.
5. The Increment button must be pressed repeatedly to increase the
PWM signal to the valve. Each press will increase the signal by 2
PWM. The Channel Pulse Count and Channel Frequency Filter values
will display the current output of the feedback sensor.
6. Press the Decrement button to decrease the PWM signal and close
the valve. The Decrement button must be pressed repeatedly to
decrease the PWM signal to the valve. Each press will decrease the
signal by 2 PWM.
7. The active channel is displayed in the button text.
8. Turn the master switch off to shutdown control channel.
INFORMATION SCREEN
The Information screen displays the module software versions connected to
the system and is typically used for service and troubleshooting. No
information on this screen can be edited.
Each module connected is identified by module type, module position, and
serial number. Module position cannot be altered on this screen and can
only be established on the Module Configuration screen.
Press the Information button to access the Information screen.
NOTE: The Password button on the
Information screen provides
access to the Password screen
to change User Levels.
Passwords are available to
Great Plains’ authorized users.
Figure 8
Information Screen